THE USE OF THE PEDALS – Jeffrey Chappell (2022)

I. Preface

There are three pedals on the piano: the damper pedal on the right, played with the right foot; the soft pedal on the left, played with the left foot; and the sostenuto pedal in the middle, played with the left foot.

In all cases, the end of the pedal should contact the ball of the foot in line with the big toe. The heel of the foot stays on the floor at all times, and the foot remains touching the pedal at all times.

II. The Damper Pedal

When a key is depressed, the corresponding damper is raised off the strings simultaneously, allowing the strings to vibrate. When the key is released, the damper returns to its resting place against the strings and “damps” the vibrations, stopping the sound.

When the damper pedal is depressed, all the dampers at once lift from the strings, and return when the pedal is released.

This simple situation has complex ramifications.

(Video) What do the pedals on a piano do? | Cunningham Piano Company, Philadelphia, King of Prussia, PA

When a note is struck on the piano while the damper pedal is down, the vibrations from the strings of that note cause other strings to vibrate as well. These new vibrations are called sympathetic vibrations, and will mostly be pitches from the overtone series of the principal note. Since the resonance of the entire instrument is called into play, the chief effect of the damper pedal is a change in the sound quality of the piano. Therefore, the primary use of the damper pedal is to manipulate the sound quality.

Basically, the quality of sound with the pedal in use is a fuller, more fluid resonance than without the pedal, which is a dryer, flatter kind of sound. This difference is easily heard.

To lift and then to depress the pedal, starting from the down position, is to change the pedal.

It is unnecessary to raise and lower the pedal completely every time you change it. On most pianos, the pedal can be lowered nearly an inch before it connects to the damping mechanism. Don’t waste time and effort moving the pedal through this empty space. It has no effect on the sound. If necessary, experiment, slowly repeating a staccato note as you lower the pedal by fractions of an inch until it starts to catch the sound. This is the level from where you begin each descent of the pedal and to where you allow it to return.

The timing of the pedal changes can vary, with varying results. Most of the time, the pedal is changed immediately following the striking of a note. This produces a smooth transition from one sound to the next and eliminates blurring of sounds.

(Video) The Four Cable Method - by Jon Chappell

When the pedal is depressed before the note is struck, all strings are available to resonate, and the sound will have all of its richness from the beginning. This is especially important to remember on the first chord of a piece or whenever the music continues after a rest.

The pedal can be depressed exactly at the same time as the note is struck. Usually, the pedal and note will be released simultaneously as well when this technique is used: the hand and foot coordinate their down-up movements. This creates an accent on the pedaled note by adding a richness of sound to it while its neighbors remain “dry”.

When the pedal is depressed relatively late after the note is struck, there is a noticeable change in the sound quality in the middle of its duration. This is rarely desirable and creates an odd effect that passes unnoticed by many students. It is particularly apparent on the first chord of a piece or whenever the music continues after a rest. However, this effect can be put to good use when one wants to give the illusion of a crescendo on a held note.

The pedal can be applied lightly and flexibly during pieces in a fast tempo or during runs and passagework. Characterized by frequent and irregular changes, this type of pedaling is called surface pedal. This gives substance to the tone without blurring the sounds.

Between the level where the pedal first engages the damping mechanism and the lowest position of the pedal are any number of subtle degrees. These are collectively referred to as half pedal. Familiarize yourself with half pedal effects through experimentation.

(Video) Golden Buzzer: Chapel Hart Wows The Judges With Original, "You Can Have Him Jolene" | AGT 2022

Generally, the pedal should be changed as often as necessary to sustain clarity when harmonies change and during fast-moving melodies.

However, in works where a lustrous sound quality is desirable throughout, this last consideration is modified by the following situation: in a succession of notes played with the pedal down, the ear follows the most recently played note if all the notes have been played at the same dynamic level or with a crescendo. If there has been a diminuendo, we still hear the first, or loudest, note that was played. Therefore, one can pedal through a succession of different pitches while treating the dynamics carefully.

While it is held down, the pedal accumulates sound with each additional note struck. This property can be used to create or enhance a crescendo, particularly in a context of fast note values where little pedal is being used. Conversely, by lifting the pedal slowly, there is a gradual decrease in the sound, which creates a diminuendo. Thus, without the involvement of the arms, hands, or fingers, the pedal can be used to produce dynamic changes effortlessly.

Please notice that a pedal change creates an articulation in the sound texture. With the pedal down, the sound accumulates. The pedal change cancels that accumulation and causes a break. An easy demonstration of this is to hold down a chord and then change the pedal several times in a row. In practice, this property can be used to subtly create or reinforce an accent; or to emphasize a structural division such as the strong beats of a measure or the beginning of an independent phrase.

When a note or chord is repeated at a slow to moderate tempo, the choice must be made of whether or not to change pedal on each repetition. Changing will be cleaner and more pleasing generally, unless the desired effect is the accumulation of sound.

(Video) Audition Full Explanation

Because the larger bass strings have larger vibrations than the other strings in the piano, an extremely rapid pedal change may fail to completely damp them. Thus it is possible to change the pedal in such a way that clears the sound in the upper registers while permitting the bass notes to continue.

There is one use of the pedal which is desirable only as a last resort. When it is awkward or impossible to connect notes using a legato touch, it is necessary to make the connection by sustaining the sound with the pedal. Unfortunately, many students make this the main function of the damper pedal and never develop legato playing. Please remember that the primary use of the pedal is to manipulate sound quality. Legato is controlled with your fingers, not your feet.

III. The Soft Pedal

Throughout the major upper section of the keyboard range, each note has three strings; in the lower range each has two, while the lowest notes have only one. On a grand piano, the soft pedal shifts the entire action slightly to one side so that the hammers strike one less string per note (or, in the lower bass range, the hammers strike off-center). This creates a sound which is more muted and less vibrant than without the soft pedal. Therefore, the primary use of the soft pedal is to manipulate sound quality. It is employed to create an atmosphere of mystery, other-worldliness, distance, inwardness, fantasy, et cetera.

Unusual effects can be achieved by depressing the soft pedal to various intermediate degrees instead of all the way down. However, these are very subtle, specialized, and rare.

There is another use of the soft pedal which is desirable only as a last resort. Since the soft pedal produces a slight reduction in volume, many students make this the main function of the soft pedal and never develop the ability to play softly without it. A pianist can play perfectly loudly with the soft pedal down. Please remember that the primary use of the soft pedal is to manipulate sound quality. Dynamics are controlled with your arms, hands, and fingers, not your feet.

(Video) Joe Rogan Meets Tyrone Biggums on “Fear Factor” - Chappelle’s Show

IV. The Sostenuto Pedal

The sostenuto pedal acts as a selective damper pedal by sustaining specifically chosen notes. To use it, play and hold down a note or chord. Then depress the sostenuto pedal. After releasing the keys, those notes will continue to sound until the sostenuto pedal is released. The damper pedal can be changed while the sostenuto pedal is down without affecting the notes held by the sostenuto pedal. This pedal is ordinarily used in organ-like textures to sustain long bass notes below changing harmonies (“pedal point”).

Jeffrey Chappell © 1982

Listen to Jeffrey Chappell being interviewed about a life in music in this half-hour “Muse Mentors” podcast from October 2020.


THE USE OF THE PEDALS – Jeffrey Chappell? ›

There are three pedals on the piano: the damper pedal

damper pedal
A sustain pedal or sustaining pedal (also called damper pedal, loud pedal, or open pedal) is the most commonly used pedal in a modern piano. It is typically the rightmost of two or three pedals. › wiki › Sustain_pedal
on the right, played with the right foot; the soft pedal on the left, played with the left foot; and the sostenuto pedal in the middle, played with the left foot. In all cases, the end of the pedal should contact the ball of the foot in line with the big toe.

What are the three pedals under a piano for? ›

There are three pedals on the grand piano – they are named, from left to right, the una corda, sostenuto, and damper pedal. The purpose of the pedals is to change the tone of the piano in some way.

What is the Sostenuto pedal used for? ›

On grand pianos, the middle pedal is known as a Sostenuto pedal. This pedal only holds notes that have been “locked” with the fingers, keeping the other notes free to be controlled by the other pedals or with the fingers alone.

How do you use the pedals on a piano? ›

How To Use A Sustain Pedal - Piano Lesson (Pianote) - YouTube

When should I use soft pedal? ›

When to Use the Soft Pedal on the Piano - FREE PIANO LESSONS

When should I use left pedal on piano? ›

On a grand piano, the keyboard moves, or shifts, to the left when the una corda is depressed. This is because the hammer strikes one string less than usual, hence the name, una corda, or one string.

Do you need 3 pedals for piano? ›

For most players, having two or three pedals isn't a big factor when buying a grand piano. If you play a lot of contemporary music then it could be important for you to have three pedals on a grand piano. For the majority of pianists though, two pedals will not present much of a limitation to your playing.

How do I know when to push my piano pedals? ›

The short answer is you should hold down the pedal whenever you want your notes to sustain, and release it whenever you want them to stop. To learn when the notes SHOULD sustain, your suspicion about the Ped.

How do I read my pedal markings? ›

The “ped” marking indicates that you should press the pedal down, while the asterisk indicates that you should release the pedal. Alternately, a line below the staff also indicates when to depress and release the pedal.

Do pianists use the soft pedal? ›

The soft pedal is something that every pianist must learn to utilize effectively. While it's commonly referred to as the “soft pedal” its actual name is the una corda pedal. Today we are going to discuss when and how to use the soft pedal effectively in your music. Una Corda actually translates to “one string”.

Is a damper pedal the same as a sustain pedal? ›

The first pedal we will learn about is called the sustain pedal or damper pedal. These two words are often used interchangeably to refer to the same pedal. On all acoustic grand or upright pianos, the sustain pedal is on the right side.

What does the first pedal on a piano do? ›

The soft pedal, or una corda pedal, was invented by Bartolomeo Cristofori. It was the first mechanism invented to modify the piano's sound. This function is typically operated by the left pedal on modern pianos.

How often is the sostenuto pedal used? ›

How often do you use the sostenuto (middle) pedal? The sostenuto pedal, which is often the middle pedal if there are three, sustains only those notes that are held when the pedal is pressed; any notes played after are not held.

What does sostenuto mean in music? ›

Definition of sostenuto

(Entry 1 of 2) : sustained to or beyond the note's full value —used as a direction in music.

Why does my piano only have 2 pedals? ›

If you only have two pedals in total on your piano, the right will be the sustain pedal and the left will be the una corda pedal. These other two pedals are not used as often as the sustain pedal, yet they can add so much more colour, variety and texture to our playing.

What do the first two pedals on a piano do? ›

What do the pedals on a piano do? - YouTube


1. Music Licensing – How Does It Really Work?
2. Muse - Unsustainable Cover
3. Chappelle's Show - Tyrone Biggum's Crack Intervention
(Comedy Central)
4. Wheel of Fortune Player Was Acting Strangely With Her Letter Pick, Then Pat Sajak Realize Why
(Facts Verse)
5. Russell Peters stand-up comedy full video
(The Anonymous)
6. New Strymon V2 Pedals - Deep Dive & Hands-On!
(Andertons Music Co)

Top Articles

Latest Posts

Article information

Author: Gov. Deandrea McKenzie

Last Updated: 01/07/2023

Views: 5397

Rating: 4.6 / 5 (46 voted)

Reviews: 85% of readers found this page helpful

Author information

Name: Gov. Deandrea McKenzie

Birthday: 2001-01-17

Address: Suite 769 2454 Marsha Coves, Debbieton, MS 95002

Phone: +813077629322

Job: Real-Estate Executive

Hobby: Archery, Metal detecting, Kitesurfing, Genealogy, Kitesurfing, Calligraphy, Roller skating

Introduction: My name is Gov. Deandrea McKenzie, I am a spotless, clean, glamorous, sparkling, adventurous, nice, brainy person who loves writing and wants to share my knowledge and understanding with you.